Getting The Best Swim Spa Cover

Swim Spas represent unique difficulties when it concerns covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same reasons a hot tub requires a cover. The obstacle is that because of the length of the swim spa and the height of the sides, eliminating and changing the cover can be a lot more difficult.
Getting a new swim spa is an exciting event in life. You’re anticipating the exercise you’ll obtain from using it. Perhaps you’re a little relieved to have finally made a selection from the various models you looked at. At any rate, you most likely weren’t believing much about the cover you would use.
Normally, the cover that gets back with your new purchase will be a four section stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence because as quickly as it is put in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper won’t make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are really small as they rise from the water surface area. They make their method into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It takes place slowly and on a Swim Spa Cover which is made from individual areas, at differing speeds. So eventually you’ll notice a couple of of the areas are actually getting heavy. The bar lifters on completions of the swim spa aren’t much assistance due to the fact that you still have to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually end up in some garbage dump, they developed one that uses air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or fall apart at the joints either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the cover for it.
If you’re not prepared to purchase today, bookmark this site so you can discover it again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *