The Challenges to Swim Spa Covers

Swim Spas represent unique obstacles when it concerns covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The difficulty is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot harder.
Getting a new swim spa is an amazing occasion in life. You’re eagerly anticipating the workout you’ll get from using it. Perhaps you’re a little relieved to have finally made a selection from the various designs you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Usually, the cover that gets back with your new purchase will be a 4 section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it starts to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style defect. Integrated in obsolescence since as quickly as it is put in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are extremely little as they rise from the water surface. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It takes place gradually and on a Swim Spa Cover which is made from specific areas, at differing speeds. So eventually you’ll see a couple of of the areas are actually getting heavy. The bar lifters on completions of the swim spa aren’t much help since you still have to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a different design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will ultimately wind up in some land fill, they designed one that uses air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or break down at the seams either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to buy today, bookmark this website so you can find it again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *